W6 Internal Oak Room Divider Set

Prior to installation, it is essential to coat all faces and edges of both

the frames and the doors with a good quality sealer to protect from

moisture ingress.

At least 3 topcoats will be necessary on top of the sealer coat to

adequately seal and protect the wood.

Failure to undertake this may result in shrinkage, warping, twisting

and splitting of the frame and the doors.

Water based stains, paints or varnishes are not recommended.

The brick wall should be lined with polythene in between the

brickwork and the frame.

The opening of the plasterboard faced stud wall needs to be lined

with wood onto which the frame can be fixed.

If the wall is thinner than the frame width (133mm) the frame width

can be reduced.

Pre-glazed Oak with clear bevelled glass