Oak Oslo W8 Room Divider Set

Finishing

Prior to installation, it is essential to coat all faces and edges of both the frames and the doors with a good quality sealer to protect from moisture ingress.

At least 3 top coats will be necessary on top of the sealer coat to adequately seal and protect the wood. Failure to undertake this may result in shrinkage, warping, twisting and splitting of the frame and the doors.

Water based stains, paints or varnishes are not recommended.

Installation

Brick Wall [ W4, W6 & W8 ]

The brick wall should be lined with polythene in between the brickwork and the frame.

Stud Wall [ W4, W6 & W8 ]

The opening of the plasterboard faced stud wall needs to be lined with wood onto which the frame can be fixed. If the wall is thinner than the frame width (133mm)
the frame width can be reduced.

Finishing

Prior to installation, it is essential to coat all faces and edges of both the frames and the doors with a good quality sealer to protect from moisture ingress.

At least 3 top coats will be necessary on top of the sealer coat to adequately seal and protect the wood. Failure to undertake this may result in shrinkage, warping, twisting and splitting of the frame and the doors.

Water based stains, paints or varnishes are not recommended.

Installation

Brick Wall [ W4, W6 & W8 ]

The brick wall should be lined with polythene in between the brickwork and the frame.

Stud Wall [ W4, W6 & W8 ]

The opening of the plasterboard faced stud wall needs to be lined with wood onto which the frame can be fixed. If the wall is thinner than the frame width (133mm)

the frame width can be reduced.